HP zx6000 Release Notes

Release Notes for HP OpenGL for HP-UX 11.23 (June 2003) on IPF-Based Systems
----------------------------------------------------------------------------
Note: These release notes are cumulative and contain information about the HP-
UX 11.23 Operating Environment June 2003 release.
For additional information about HP's implementation of OpenGL, go to
http://www.hp.com/support/workstation_manuals.
1. ANNOUNCEMENTS
N/A
2. WHAT'S IN THIS VERSION?
Support of new devices: ATI FireGL X1 and FireGL Z1
Note: 2D/3D Distributed Single Logical Screen (SLS/d) for OpenGL is not
supported with this release.
See the following documentation for additional information:
* The "Addenda -- Additional Graphics Information" section of this document
* OpenGL Implementation Guide
* Graphics Administration Guide
* OpenGL and Common Graphics Release Notes located in
/opt/graphics/common/ReleaseNotes
These documents can also be viewed at
http://www.hp.com/support/workstation_manuals.
3. KNOWN PROBLEMS AND WORKAROUNDS
N/A
4. COMPATIBILITY AND INSTALLATION REQUIREMENTS
Software Requirements
=====================
The version of OpenGL shipped with the HP-UX 11.23 Operating Environment June
2003 release requires the use of the HP-UX 11.23 Operating Environment June
2003 release or later.
Hardware Requirements
=====================
For detailed information about supported graphics configurations (HP-UX
computers combined with bit-mapped graphics devices) consult the Graphics
Administration Guide.
Disk Space Requirements
=======================
Use the "swinstall" command to determine the necessary and available disk
space for the 3D graphics application programming interface (API) you wish to
install.