Setting Hardware Passwords In The Hp Setup Program; To Set A Password - HP workstation xw5000 Getting Started Manual

setting hardware passwords in the hp setup
program

to set a password

getting started guide
Power LED. These LEDs indicates system status:
Solid green — system is on.
Solid yellow — workstation is in Standby or Hibernate mode.
Flashing yellow, flashing red, or solid red — system error.
Reset button. Press this button to re-initialize all the hardware
without cycling power to the system (soft boot). Avoid general use of
this button because file damage may occur. Always use the OS Shut
Down command before resetting the machine.
Hard Disk Activity LED. Flickers when your hard disk is being
accessed.
You can set hardware passwords to provide different levels of
protection for your workstation: the Administrator password and
the User password. You set the passwords using the Security menu
in the Setup program.
The administrator can access and change all settings in the Setup
program, while the User can only access and modify certain items in
the Main menu.
1. Start the Setup program.
2. Select the Security menu.
3. Select the Administrator or User Password submneu.
4. Select the Set Administrator or User Password setup item. You
must enter your password twice.
5. To save your changes and exit the Setup program, press Esc or
select Exit Menu, then select Exit Saving Changes.
To remove the password, follow the same procedure to set a
password. You will be asked to enter the existing password first.
Then, for the new password leave the password field blank and press
Enter. To confirm your choice, press Enter a second time.
setting up and using your workstation
1–11