HP Vectra VL5 4 Supplementary Manual page 42

3 Troubleshooting and Repair
Using SETUP to Configure the PC
Setup Item
Memory and Cache
Memory caching
Memory hole
Shadow/Cache ISA Option
ROMs
Hard Disk Drives
Hard disk drive 0 (xxxx MB) 540 MB
Hard disk drive 1 (xxxx MB) xxx MB
Hard disk drive 2 (xxxx MB) xxx MB
Hard disk drive 3 (xxxx MB) xxx MB
Translation method
On-board Bus IDE adapters
Autotype fixed disk
Type
Cylinders
Heads
Sectors/Track
Multi-sector transfers
LBA mode control
32 bit I/O
Transfer mode
44
Default Action
Both Controls internal (L1) and external cache (L2) memory
caching.
Disabled Sets a 1MB memory hole between 15 and 16MB if
needed. You need at least 16 MB for this option to be
available.
Enabled Enables shadowing and caching for ISA "Non-PnP" Option
ROMs for region X-Y, in order to improve performance.
Note that some Option ROMs cannot be shadowed.
Configure IDE drive 0. It is not recommended to connect a
CD-ROM on a channel which already has an IDE hard disk
drive. Sub-menu items for each of these fields are given
below "On-board Bus IDE adapters" in this table.
Extended Select "Standard" only if you are running a UNIX
Operating System.
Both Enable or disable the on-board IDE adapters.
"Primary" enables only the HDD data cable (marked
"HDD" next to the system board attachment).
"Both" enables the HDD data cable and the CD-ROM data
cable (marked "CD-ROM" next to the system board
attachment).
Automatically attempts to detect and identify the IDE
drive when you press the Enter key.
User 540 MB Select "Auto" for automatic hard disk drive detection. (To
initiate automatic hard disk detection, press the Enter key
at the "Autotype fixed disk" item). "User" allows you to
edit all the detected parameters. Select "CD" if drive is an
IDE CD-ROM, and "None" if there is no drive.
944 Sets the number of hard disk drive cylinders.
14 Sets the number of hard disk drive heads.
40 Sets the number of hard disk drive sectors per track.
8 sectors Determines the number of sectors per block for multiple
sector transfers.
Enabled Enable or disable Logical Block Addressing mode in place
of Cylinder Heads Sectors.
Enabled Enable or disable 32 bit data transfer.
PI0 mode 3 Selects the hard disk drive transfer mode and data
transfer rate.