Configuring Non-Plug And Play Isa Accessory Boards - HP Vectra VEi7 Supplementary Manual

Resetting the PC's
Configuration Data
2 How to Install and Upgrade Accessories In Your PC
Installing Accessory Boards

Configuring non-Plug and Play ISA Accessory Boards

If you install an ISA accessory board that is not Plug and Play, you will
need to configure the board before your PC can use it. For instructions
about configuring the board, refer to the documentation that came
with the board.
For guidelines on available IRQs and I/O addresses in your PC, refer to
page 75. Some operating systems, such as Windows 95, can display the
IRQs and I/O addresses currently used by your PC. Refer to the
operating system documentation for more information.
Refer to the documentation supplied with the operating system for
details on your operating system's capabilities and restrictions
concerning non-Plug and Play accessory boards.
If your PC is having difficulties recognizing the ISA board, try resetting
the PC's data configuration. This will clear any old configuration data
that is no longer used. To do this, enter the PC's Setup program, set the
Reset Configuration Data
restart the PC. To enter the Setup program, press
62
parameter in the Advanced menu to Yes , and
during startup.
F2