Creating A Raid Volume - HP ProLiant ML110 User Manual
Hp proliant ml110: user guide
Hide thumbs
Also See for ProLiant ML110:
- Operation and maintenance manual (115 pages) ,
- Operating system installation manual (49 pages) ,
- Quickspecs (27 pages)
Table of Contents
Advertisement
NOTE:
RAID driver. If this option is not enabled, the OS loads the standard ATA driver from the OS
media.
During POST, press the F10 key to launch BIOS Setup Utility. If you fail to press F10 before POST,
2.
you will need to restart the server.
In the Advanced menu screen, select Hard Disk Configuration.
3.
Set the Configure Controller 1 field to RAID.
4.
Press F10, then select Yes to save the changes and close BIOS Setup Utility. The server automatically
5.
reboots.
Create a RAID volume
6.
ProLiant ML115 and ML115 G5 Servers
CAUTION:
process erases all data on the hard drives.
Power up the server. If the server is already powered, save all data, exit all open applications, and
1.
restart.
NOTE:
RAID driver. If this option is not enabled, the OS loads the standard ATA driver from the OS
media.
During POST, press the F10 key to launch BIOS Setup Utility. If you fail to press F10 before POST,
2.
you will need to restart the server.
In the Advanced menu screen, select HDD Configuration.
3.
Select the SATA RAID Setup field.
4.
Set the SATA RAID Function field to Enabled.
5.
Set the appropriate SATA channels for RAID to Enabled.
6.
Press F10, then select OK to save the changes and close BIOS Setup Utility. The server automatically
7.
reboots.
Create a RAID volume
8.
Creating a RAID volume
Servers with Intel® Celeron®, Xeon®, Pentium® 4, and Pentium® D processors
Enable SATA RAID functionality in the BIOS Setup Utility
1.
BIOS Setup
After the system reboots, activate the RAID Configuration Utility:
2.
For ProLiant ML110 G2 and ML150 G2 Servers, press CTRL+A.
o
For ProLiant ML110 G3, G4, G5, and ML150 G3 Servers, press F8.
o
From the Option menu, select Array Configuration Utility.
3.
Verify that two SATA drives are installed.
4.
In the Main menu screen, select Create Array from the main menu. The system prompts a selection of
5.
RAID 0, RAID 1, or RAID 10.
Enabling the RAID option in BIOS Setup Utility is only necessary for installation of the
("Creating a RAID
Back up any data stored on the hard drives before proceeding. The configuration
Enabling the RAID option in BIOS Setup Utility is only necessary for installation of the
("Creating a RAID
Utility" on page 51).
volume" on page 53).
volume" on page 53).
("Enabling SATA RAID functionality in the
Server software and configuration utilities 53
Advertisement
Table of Contents
Troubleshooting
