Powering On The Phone - Cisco Unified Wireless IP Phone 7921G Phone Manual

If you want to...
Stop Found New
Hardware Wizard
from opening when
connecting to USB
port

Powering On the Phone

After charging the battery, you must power on the phone to make and receive calls.
If you want to...
Power on the phone
Check signal strength The
Tip
Your idle phone screen can turn off after a time interval. To alert you that the phone is still powered
on and connected to the wireless network when using battery power, the indicator light blinks green
every two seconds.
12
Then...
1. Click Next to use the wizard dialog box.
2. In the Update New Software dialog, click No, not this time, and click
Next.
3. Click Install the Software automatically (Recommended) and click Next.
4. After a few moments, the Cannot Install This Hardware dialog displays.
Click Don't prompt me again to install this software.
5. Click Finish to close the dialog box.
Then...
1. Press and hold the
2. You might need to enter a username and password to access the wireless
network. For more information, see
page 13.
3. After completing authentication and registration with Cisco Unified
Communications Manager, the phone displays the main screen and is
ready to place or receive calls.
icon indicates the strength of the signal between the wireless access
point and your phone. Your phone must have at least one bar to place or
receive calls.
When you move the phone out of signal range, you lose connection with the
wireless LAN. The
service area."
(red button) until the phone powers on.
Setting Username and Passwords,
icon appears, and the status line displays, "Leaving
OL-16131-01