Installing Additional Drives - HP Pro 3000 MT Hardware Reference Manual

Installing Additional Drives

When installing additional drives, follow these guidelines:
● The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
connector on the system board.
● Connect the first SATA optical drive to the white SATA connector on the system board.
●
Always populate the dark blue and white connectors before the light blue and orange connectors.
●
The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.
● If needed, HP has provided extra drive retainer screws on the interior of the front bezel that are
used to secure the drives in the drive cage. Hard drives use 6-32 standard screws. All other drives
use M3 metric screws. The HP-supplied M3 metric guide screws (1) are black. The HP-supplied
6-32 standard screws (2) are silver.
Figure 14
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer,
and unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, refer to Appendix
A, Electrostatic Discharge on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label
the package "Fragile: Handle With Care."
14 Hardware Upgrades
Extra Drive Retainer Screws Location
To prevent loss of work and damage to the computer or drive:
35.