Ending A Call; Using Hold And Resume - Cisco 7931G User Manual

Ending a Call

To end a call, simply hang up. Here are some more details.
If you want to...
Hang up while using the handset
Hang up while using a headset
Hang up while using the speakerphone Press

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
line display on the phone screen, and the corresponding line button flashes green
If another user put a shared line on hold, its associated line button displays
anyone else sharing that line) can resume the call.
If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts back to
ringing after a certain period of time. The "reverting" call remains on hold until you resume it or until
Hold Reversion times out.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a line button
If you want to...
Put a call on hold
Remove a call from
hold on the current line
Tips
• Engaging the Hold feature typically generates music or a beeping tone.
30
Then...
Return the handset to its cradle. Or press EndCall.
Press
EndCall.
(flashing, depending on the line state).
Then...
1. Make sure the appropriate call is highlighted.
2. Press .
• Press (flashing),
• Make sure the appropriate call is highlighted and do one of the
following:
Press Resume.
–
Press .
–
( ). Or, to keep headset mode active, press
or EndCall.
next to the caller ID for the held call.
(flashing), or (flashing) for the held call, or
appears next to the
.
(flashing). You (and
OL-15791-01