Table of Contents
Advertisement
If the computer does not work properly when
you wake it from standby, reset the computer:
press and hold the On button on the front of the
PC for approximately 5 seconds until the system
turns off. Then turn the computer back on.
Note:
Using the On button to reset the system is not
recommended and should be used only as a last
resort.
Hibernation Mode
When the computer is in hibernation mode, it
saves everything that is in computer memory to
the hard disk, turns off the monitor and the hard
disk, and then turns itself off. When you turn on
the computer, everything (programs, folders, and
documents) is restored to the screen.
To manually put the computer into hibernation:
1 Click Start on the taskbar.
2 Click Turn Off Computer.
3 Click Hibernate.
Note:
If Hibernate is not present, you first need to set
up your computer for hibernation; refer to steps
1 through 6 of "Automatic Standby or
Hibernation Mode" on page 28.
4 When you want to use the computer again
after hibernation, press the On button on the
front of the PC.
If the computer does not work properly when
you wake it from hibernation, restart the
computer:
1 Click Start on the taskbar.
2 Click Turn Off Computer.
3 Click Restart.
27
Quick Start Guide
Advertisement
Table of Contents
