Connecting The Signal Source - HP Media Center,Pavilion Media Center m200 Hardware Manual

Connecting the Signal Source

This section describes connecting the signal source
for TV.
Connect the signal source for the TV by using the TV (in)
coaxial connector or the S-VID IN (s-video) connector:
Plug the connector of a coaxial cable from your TV
antenna or from your TV cable (wall or set-top box)
into the TV connector on the back of the PC, and then
turn the connector to tighten it.
Or
Plug a cable into the S-VID IN connector on the back
of the PC: use an s-video cable (not provided) or use
the s-video to composite video adapter cable and
the composite video cable. Plug the other end of the
cable into your set-top box, VCR, or other device that
is providing the signal source for the TV.
You can also plug audio cables (not provided) from your
set-top box or VCR into the Audio in right (red) connector
and the Audio in left (white) connector on the back of
the PC.
Left audio in S-VID IN
(white) (s-video)
Right audio in
(red) TV in
n
Select the signal
source for TV in
the Media Center
program settings.
11