To Connect Your Multi-Channel Speaker System To The Pc - HP Media Center,Pavilion Media Center 884 Supplementary Manual

Select PCs have the multi-channel audio capability
that uses the microphone, Audio (Line) In, and
Audio (Line) Out connectors on the back of the
PC. If your PC has these connectors, perform the
procedure "Installing multi-channel audio
speakers" on page 4 of this document.
Installing Creative Audigy for speakers
After you turn on the PC for the first time and
complete the initial onscreen setup, do the
following so that your speakers work properly:
1 Close any open programs.
2 Click Start on the taskbar, choose All
Programs, Creative, and then click Install
Application for Creative Audigy.
3 The Audigy Application Setup window opens.
Click OK.
The InstallShield Wizard begins the installation
and automatically restarts the PC when the
installation completes.
4
Updated HP Media Center PC Information
Note:
If you do not do this procedure, the speakers may
produce an audible pop when the PC wakes from
standby or hibernation.
Installing multi-channel audio speakers
If your PC has multi-channel speakers capability
(select models only), you can connect speakers for
4-channel or 6-channel output. You must connect
your speaker system to the PC, and then configure
the audio software for sound output.
Note:
Multi-channel audio uses the Microphone,
Audio (Line) In, and Audio (Line) Out connectors
on the back of the PC to connect the multi-channel
speakers system to the PC.
To connect your multi-channel
speaker system to the PC
1 Turn off the PC.
2 Connect the three audio cable plugs from the
speaker system to the connectors on the back
of the PC (see the table).