Answers And Explanations - HP Kayak XU03 User Manual

Answers and Explanations

Answers and Explanations
Can a 256 MB registered ECC memory module be mixed with a
1
non-buffered ECC SDRAM memory module?
b No, it cannot. Registered and non-buffered memory modules are
not compatible.
Can a maximum of 512 MB of non-buffered ECC SDRAM memory
2
modules be installed on HP Kayak XA-s, XU, and XW Series U3
and W3 PC Workstations?
b No. On the HP Kayak XA-s, there are only three DIMM sockets
available.
For models with the HP FastRAID2 I/O Subsystem, can you boot
3
from the Windows NT CD-ROM when replacing a disk drive?
b No, because the new hard drive will not be found.
Where can you find all of the HP FastRAID software (ArrayConfig,
4
drivers and CI/O Manager) and Operating System Installation
notes (such as Windows NT 4.0)?
a & b The HP Kayak XU/XW PC Workstation Drivers CD-ROM
contains this software. The most recent updates may be obtained
from the HP WWW site.
To run the MaxiLife diagnostics program, does the computer
5
need to be powered on?
b No, it doesn't. The HP MaxiLife is always running and
continuously monitors the state of the LCD buttons. (The power
cable must always be connected.)
Can the Internal SCSI 16 Bits (Adaptec) and External/Internal 16/
6
8 Bits (Symbios) options be set to enabled at the same time?
b No, these two utilities cannot be loaded at the same time.
c This is not possible on HP Kayak XA-s PC Workstations.
38