Advertisement
8.4 Installation Procedure
Step-1
Push out cover lock from
base slot.
Remove cover
c
a
b
Step-3a
Installation on the wall
Extrude plugs
of selected
mounting
holes
Step-4
Make marking on the wall at the required height applying
the base to installation surface.
Detector base should be positioned strictly as per
3a
figure of the step
.
Step-5
There is a possibility to
install
detector
using
universal
or
swinging
bracket, for which purpose
it is required to push out
end cap of lead on the
base.
Note – Bracket is supplied
separately
Step-6
Lead wires from power
supply
source
signaling zones through
wire insertion hole on the
base.
Fix the base on the wall or
in the corner of the room.
Step-7
Install printed circuit board
on its place
5-av8_2_en
Step-2
Unbend hooks of the base.
Remove PCB.
Hooks
Step-3b
Installation in the
corner
and
Step-8
Connect wires led to detector
terminals
For
connection
resistor,
terminal RES is provided
Step-9
Using sealing material of distribution kit seal hermetically
wire insertion hole and other holes to protect detector from
air and insects ingress
Step-10
Install jumper on Ind plug and
Sens plag.
Remove jumper from Mem plug.
Extrude plugs
of selected
mounting
holes
Step-11
Power detector up, indicator flashes 1 time per 1 s. during
60s – starting of detector working mode.
Step-12
During starting of detector operating
mode remove for a short period of
time (2-3s) and install back jumper of
Ind plug (TEST-pass mode switches
on for 8min)
For universal
bracket
For swinging
Step-13
bracket
Install detector cover on its
place (until the click)
Step-14
To detect sensitive zones carry
out TEST-pass
zone with the speed of 0,3 m/s.
On detection (indicator is lighted
for 2s) one should stop, mark this
position, then make step back and
continue moving.
Repeat TEST-pass inversely.
Sensitive areas formed by lens will
be in the middle of the marked
positions.
3
convenience
in
of
terminal
the
additional
in the secured
Advertisement
