HP j6700 Installation Manual page 5

tions. Follow the instructions below to install cards in the j6000 PCI Cage Assembly.
1
- Lift PCI handle to remove cage from workstation
1. Slide PCI retainer back
2
2. Lift off cage
- Insert I/O card in PCI slot as shown
3
- Insert bulkhead screw
3. Slide the card into the appropriate slot (see #3 above), ensuring that you align Bulkhead Pin(s),
Board Connector(s) and Board Guide(s). Make sure cards are fully seated in their connectors
before replacing the PCI Cage Assembly.
4. Plug the AC power cord into the workstation and power on the workstation.
5. Refer to your workstation documentation for instructions on using the HP-UX System Adminis-
tration Manager (SAM) utility to verify your graphics configuration
CAUTION The j-Class workstations supply about 75 Watts of power to the PCI slots. Do not insert
cards that together draw more than 75 Watts, or damage to the workstation may result.
Please look at the specifications that come with your individual cards for power
requirements. Note that each j-Class PCI slot can provide up to 25 watts.
c3650 and c3700 I/O Cards
Your HP c3650 and c3700 computer's PCI assembly has six slots. Slots 1 through 4 are full-size PCI
2
D
A R
1
I C
R
I N E
P C
T A
R E
Bulkhead
screw