Download Print this page

HP Compaq Presario,Presario SR1309 Supplementary Manual: Automatic Standby Or Hibernation; Restarting The Pc

Hp compaq presario,presario sr1309: supplementary guide.
Hide thumbs


PC Basics Guide
If the PC does not work properly when you wake it from hibernation, follow these
steps to restart the PC:
1 Click Start on the taskbar.
2 Click Turn Off Computer.
3 Click Restart.

Automatic Standby or Hibernation

You can set your PC to go into standby or hibernation mode automatically when it
is idle for some number of minutes. To put the PC into standby or hibernation
mode automatically, modify the power management settings:
1 Click Start on the taskbar.
2 Click Control Panel.
3 Click Performance and Maintenance, if it is present.
4 Double-click Power Options.
5 Click the Hibernate tab and tick the hibernation feature. If necessary, enable
the feature by clicking the Enable hibernation box so that a tick mark appears
in it.
6 If you changed the Enable hibernation tick box, click Apply.
7 Click the Power Schemes tab to set the timers for standby and hibernation.
In the Power Schemes box, select a power scheme from the drop-down list.
Choose the settings.
To turn on automatic standby for the PC, click the time to elapse before
standby (such as After 20 mins) in the System standby list.
To set the timer for automatic hibernation, click the time to elapse before
hibernation (such as After 1 hour) in the System hibernates list.
If both standby and hibernation timers are set, the system hibernation
timer must be set for a longer time than the system standby timer.
8 Click OK.

Restarting the PC

When you restart the computer, the PC starts over using the operating system and
software in its memory. This is the simplest repair for your PC; just click Start,
choose Turn Off Computer, and then click Restart.
You may wish to install additional software programs or hardware devices on
your PC. Restart the PC after installation.


   Related Manuals for HP Compaq Presario,Presario SR1309

Comments to this Manuals

Symbols: 0
Latest comments: