Instruction Manual [ Home use only / Warranty not included ] | M100 Series CONTENTS hot gas stove, microwave or any kitchen appliance. • Do not attempt to modify it under any circumstances. Also, P.02 1. Precautions for Safe Use do not attempt to dismantle or repair it yourself.
If the device consecutive times). is damaged, do not use it and contact the HUROM Customer Service Center for an inspection or repair. • When detaching the container during operation, do so af- ter the blades come to a complete stop.
3. How to Assemble Juicer ⑤-1 ⑤-1 /⑥-1 /⑥-1 ③ ③ ⑦-5 ⑦-5 ①-3 ①-3 ④-1 ④-1 ②-1 ②-1 ① ① ②-3 ②-3 ⑦-2 ⑦-2 ⑦-8 ⑦-8 ⑦-1 ⑦-1 ⑨-2 ⑨-2 01 Match the protruded part at the top of the outer filter (⑤-1/⑥-1) with the chamber’s groove (⑦-5) to assemble.
Page 6
3-1. How to Assemble Juicer: Assembly and Disassembly of Silicone * Packings are consumables that are recommended to be replaced once every 6 to 12 months. They are Juice Cap Packing available for purchase through the Customer Service Center. (The juice may leak if the product is not assembled properly.) Extraction Packing ⑦-7...
4. How to Assemble Blender 01 01 ⑧-2 ⑧-2 ⑧-1 ⑧-1 ⑧ ⑧ ⑨ ⑨ ⑧ ⑧ ⑧-3 ⑧-3 01 01 Fit the auxiliary cover (measuring cup) (⑧-1) on the container cover (⑧-3) and turn it clockwise to lock it. 02 02 Put the desired ingredients into the container.
5. Power Switch and Jog Dial Guide < Juicer Standby Mode (container present) > < Blender Standby Mode (container present) > OPERATE Manual Mode 01 - It works when the [START/STOP] button is Turn the jog dial clockwise to operate the device briefly pressed in the Standby Mode.
6. How to Use Juicer 01 01 작동스위치 정회전 정회전 off(정지) 정지 정지상태 역회전 역회전 작동스위치 정회전 정회전 off(정지) 정지 정지상태 역회전 역회전...
Page 10
6. How to Use Juicer 01 Pull the lever on the inside of the hopper handle to open the hopper cover. ① The hopper cover opens when pulling the lever on the inside of the hopper handle. Insertion of an excessive amount of ingredients may put too much strain on the product.
7. How to Use Blender 7-1. Manual Mode 01 01 Manual Mode 01: [ Min / Max ] Speed control dial 01. Check if the container in which ingredients are inserted is installed on the product body and if the cover is closed. * If it is not prepared, please refer to How to Assemble Blender on Page 06.
Page 12
7. How to Use Blender 7-2. How to Use Auto Mode 01 01 Auto Mode: SMOOTHIE, ICE CRUSH, SOUP, GRIND, CLEANING 01. Check if the container in which ingredients are inserted is installed on the product body and if the cover is closed. * If it is not prepared, please refer to How to Assemble Blender on Page 06.
8. Food Ingredient Usage Guide for Juicer • This is a reference on how to prepare each ingredient and, in case you have specific allergies, ingredients that suit your body must be chosen. • Refer to the ingredient preparation method and select a filter that suits the ingredients. •...
9. Food Ingredient Usage Guide for Blender • When grinding ice, the ground ice should be smaller than 20mm and lighter than 200g. • Do not remove the container until the blades stop rotating completely and the jog dial returns to the stop position.
10. How to Clean Juicer After the product stops operating completely, pull out the power cord with dry hands. Even after the product is stopped, the motor will slowly come to a stop so, after the operation stops completely, wait about 3 seconds before detaching the chamber set.
11. How to Clean Blender How to use [CLEANING] Mode 01 Pour water into the container insomuch that the blades are submerged. 02 Place the container on the product body and then assemble the container cover and auxiliary cover (measuring cup) correctly. 03 Turn the jog dial to select the [CLEANING] menu in Auto Mode and then press the [START/STOP] button to wash.
12. Before Requesting for Repair Check the following before asking for repair. For follow-up service and any inquiry you may have while using the product, please contact our Customer Center, or homepage at http://www.globalhurom.com Check the manufacturer’s number or the number under the barcode when requesting for follow-up service or parts. Check if the chamber set of the juicer or the container of the blender and the It does not operate only product body are properly assembled.
If the same problem continues to occur, Er01 product. please contact the HUROM After-sales Service Center. Stop operating the product and restart it If a high voltage is applied to the product, after a few minutes.
Need help?
Do you have a question about the M100 Series and is the answer not in the manual?
Questions and answers