Canon PIXMA MP150 User Manual page 65

About "Layout" and "Trimming"
For "Layout", when the "Default setting" (selections based on the machine setting) is
selected, the machine operates based on the bordered/borderless setting specified in the
Memory card mode of the machine (MP170) or the Fit-to-Page setting when Photo Paper
is selected on the Operation Panel of the machine (MP150). Trimming is performed based
on settings on the PictBridge-compliant device.
Note
About "Image optimize"
When "Default setting" (selections based on the machine setting) is selected, the machine
operates based on the "IMAGE ENHANCEMENT" settings mode using the controls of the
machine.
If you use a Canon PictBridge-compliant device, you can select "VIVID", "NR", "VIVID+NR"
or "FACE".
(Note that these options cannot be selected for some models.)
Note
About "Date/File No. print"
By default, "Off" is selected for this machine.
If you select an image which has had the shooting date embedded in it using a camera with
the print mode, select "Off" for this function. If you select "Date", "File No.", or "Both", the
date and/or file number will be printed over the embedded date (MP170).
Note
Chapter 7
When printing onto Photo Stickers (PS-101) (16-up), use the following
settings.
1. Load Photo Stickers (PS-101) in the Auto Sheet Feeder.
2. Select "10 x 15 cm / 4" x 6"" for the "Page size", and "Photo" for the
"Media type".
3. Select "N-up" for layout, then select "16".
Some PictBridge compliant devices display the Layout option; 2-up, 4-
up, 9-up, and 16-up. In this case always select "16-up". If there are no
options on the PictBridge compliant device that correspond to 2-up, 4-
up, 9-up, or 16-up, printing on stickers is not possible.
When you are using Photo Stickers (PS-101), do not set "Borderless
Printing" in "Layout" settings.
When "VIVID" is selected, the green and blue portions of photos are
printed more vividly.
When "NR" (Noise Reduction) is selected, noise in blue portions, such
as the sky, and dark portions is removed.
When "VIVID+NR" is selected, functions of both "VIVID" and "NR" are
performed.
When "FACE" is selected, a darkened face on the photo taken against
the light is brightened.
Never disconnect the USB cable during printing.
When disconnecting the USB cable between the device and machine,
follow the instructions given in the instruction manual of the device.
Controls of the device cannot be used for the following:
– Print quality setting
– Machine maintenance
For the device operation method and troubleshooting, refer to your
digital device's manual.
Printing Photographs Directly From A Digital Camera
63