Loading Rolls In The Printer - Canon imagePROGRAF iPF6300S Basic Guide No.1 Basic Manual

Loading Rolls in the Printer

Load rolls in the printer as follows.
• Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be advanced
correctly when you turn the printer on.
• Before loading rolls, make sure the printer is clean inside the Top Cover and around the Ejection Guide . If these
areas are dirty, we recommend cleaning them in advance. (→
1
Press the Load button.
2
Press ▲ or ▼ to select Roll Paper , and then press the
OK button.
• If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press ▲ or ▼ to select Yes , and then press the OK button. Remove the paper and go to the next step.
3
Open the Roll Feed Unit Cover .
4
Holding the Roll Holder fl ange (a), load the Roll Holder
shaft into the guide grooves (b) on both sides of the Roll
Holder Slot . At this time, load the shaft so that the color
of the Roll Holder shaft (c) matches the color of the guide
groove.
• Do not release the fl anges until the holder is loaded in the Roll Holder Slot .
• Be careful not to pinch your fi ngers between the guide grooves (b) and the Roll Holder shaft (c) when
loading rolls.
• Do not force the Roll Holder into the printer with the right and left ends reversed. This may damage the
printer and Roll Holder .
• If it is diffi cult to load rolls from the front of the printer, load rolls from the back of the printer.
, If Paper is Soiled)
c
b
16
c
b
a