Operating Procedures; Turning The Unit On/Off; Setting The Film - Canon Microfilm Scanner 400 Instruction Manual

OPERATING PROCEDURES

OPERATING PROCEDURES
This section describes procedures for normal operation of the unit:
Turning the unit on and off.
Adjusting the image on the screen.
Printing the image on the screen.

Turning the unit on/off

Follow the procedure below to turn the unit on and off.
1. If you have installed an FS Controller III auto carrier, turn the
controller on first.
2. On the front of the main unit, locate the power switch on the lower
left corner then press the I side of the switch to turn the power on.
3. Turn on the power switch of the printer.
After you turn the unit on, the Print display starts to blink and will
continue to blink while the unit warms up. While the Print display
is blinking, you cannot start operation. When the Print display
stops blinking and stays on, the unit is ready for normal opera-
tion.
4. To turn the unit off, press the O side of the power switch.

Setting the film

Load the auto carrier with the film you want to view. For details
about the auto carrier installation, see the instructions you received
with the auto carrier.
14