Setting In The User Mode - Canon DR-6080 Instructions Manual

Chapter 5 Other Functions
You can select the mode of operation (user mode) for the scanner from those
listed below.
● Operation panel buzzer setting
U01-0
U01-1
● Count Only mode setting
U02-0
U02-1
● Endorser Stamp mode setting
U03-0
U03-1
● Double feed detection control settings in the Count Only mode
U04-0
U04-1
● Staple detection settings in the Count Only mode
U05-0
U05-1
● Staple detection accuracy settings
U06-0
U06-1
U06-2
● Imprinter control settings in the Count Only mode
U07-0
U07-1
● Skew detection control settings in the Count Only mode
U08-0
U08-1
● Energy-saving mode setting
U09-0
U09-1
60

Setting in the User Mode

Do not sound buzzer during key operation.
Sound buzzer during key operation (default).
Do not use the endorser in the Count Only mode (default).
Use the endorser in the Count Only mode.
Use the endorser in the check mode (default).
Use the endorser in the A4 mode.
Do not detect double feed in the Count Only mode (default).
Detect double feed in the Count Only mode.
Do not detect staples in the Count Only mode (default).
Detect staples in the Count Only mode.
Low level accuracy staple detection.
Medium level accuracy staple detection (default).
High level accuracy staple detection.
Do not use the imprinter in the Count Only mode (default).
Use the imprinter in the Count Only mode.
Do not use skew detection in the Count Only mode.
Use skew detection in the Count Only mode (default).
Do not go into energy-saving mode.
Go into energy-saving mode after 10 minutes of no operation
(default).