N Setting The Scsi Id And Terminator - Canon DR-5020 Instructions Manual

N Setting the SCSI ID and terminator

Set the SCSI ID and terminator using the DIP switch on the rear of the scanner.
The DIP switch is ON at the up position and OFF at the down position.
Default
(Terminator : OFF, SCSI ID = 2)
SCSI ID switch
Terminator ON/OFF switch
Set the SCSI ID referring to the table above.
Set unique SCSI IDs to any other built-in SCSI devices or SCSI devices
connected to the computer.
The SCSI ID default is set to 2.
Assign SCSI ID numbers ranging from 0 to 7 for each SCSI device. Do not select 7 as
HINT
this is normally assigned to the SCSI controller. If a SCSI hard disk is mounted, do not
use 0 and 1. Normally 0 and 1 are assigned for hard disks.
Set the terminator on the last SCSI device on a daisy chain to ON.
<When only the scanner is connected to your computer, or when another SCSI
device is connected on a daisy chain and the scanner is the last SCSI device on
the end of the daisy chain>
Set the terminator switch to ON.
In such a connection, be sure to set the terminator on all other SCSI devices to
OFF.
<When another SCSI device is connected as the last device of the daisy chain>
Set the terminator switch on the scanner to OFF.
In such a connection, set the terminator on the SCSI device connected as the end
device to ON.
SCSI ID
DIP switch
Terminator OFF
Terminator OFF
2.2 Installation and Connection
SW2 SW3
0 ON ON
1 ON ON
2 ON OFF
3 ON OFF
4 OFF ON
5 OFF ON
6 OFF OFF
7 OFF OFF
Terminator ON
Terminator ON, or
attach terminator.
SW4
ON
OFF
ON
OFF
2
ON
OFF
ON
OFF
25