Fuser Roller - Canon imageCLASS MF6540 Basic Operation Manual

Fuser Roller

If black streaks appear with printing, the
fuser roller in the main unit may be dirty.
Should this occur, clean the fusing roller
in the following procedure. The roller
should also be cleaned each time the toner
cartridge is replaced. Load a sheet of blank
LTR paper into the multi-purpose tray and
start cleaning.
Cleaning the roller takes approximately 100 seconds.
1
Press [Additional Functions].
2
Press [ ] or [
<ADJUST./CLEANING>, then press
[OK].
3
Open the multi-purpose tray.
10-6
4
5
] to select
6
Pull out the multi-purpose tray
extension until it clicks, then open
it.
Load a sheet of blank LTR paper.
Press [ ] or [ ] to select <FIX.
UNIT CLEANING>, then press [OK].
Cleaning starts. When finished, the display
returns to the standby mode.
– Use standard paper as the cleaning paper.
– Throw away the cleaning paper after use.