Canon Optura Pi Instruction Manual page 79

#4_OPTURA Pi_E(79-99)
4. Open the VCR menu and select
E
• When you select the DUB MODE menu all the displayed information is
also displayed on the screen of the TV connected your VCR. However, this
information will not be recorded onto the tape in the VCR.
Setting the camera to control your VCR
The camcorder's Dubbing Function
controls your VCR by using the same
infra-red signals as the VCR's remote
control.
Make sure the camera is in a spot
where it can remotely control your
VCR.
1. Check where the remote control
sensor is on your VCR using its
normal remote control.
2. Place the camera pointing
directly at the sensor, not more
than 20 inches (50 cm) away.
• Check that the sensor will pick up
signals easily from this spot using
the VCR's normal remote control.
• Make sure that the cables and the
camera's shoulder strap do not
obstruct the signals.
3. Make sure that the VCR is in record pause mode.
4. Make sure that all other video equipment is turned off to avoid
accidental recording.
80
1/25/00 13:42 Page 80 (1,1)
\DUB MODE.
Infra-red signals
transmitter