Permissible Multiengines; Mounting The Multitool - Stihl FC-MM Instruction Manual

Permissible MultiEngines

Only MultiEngines which have been
supplied by STIHL or specially approved
for use with this MultiTool may be used.
This MultiTool may only be used in
combination with STIHL MM 55.
FC-MM

Mounting the MultiTool

Removing existing MultiTools
: Wear gloves to reduce the risk of
injury from contact with sharp,
pointed MultiTools and/or the hot
surface of the gearbox.
: Remove the hitch pin and pull the
MultiTool (if fitted) off the shaft.
: Clean the gearbox if necessary.
Also refer to chapter on "Mounting the
MultiTool" in the instruction manual of
the other MultiTool.
Checking position of gearbox
1
3
To reduce risk of injury from MultiTool
rotating in the wrong direction, check
that position of gearbox is correct and
adjust if necessary.
The gearbox output shaft (1) must be
below the drive tube (2) so that the
MultiTool rotates in the direction of the
arrow (3).
English
2
11