Oven Light; Troubleshooting - Maytag MER8880AB User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Oven will not operate
Convection fan not working
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
Mineral deposits are left on the
oven bottom after the Clean
cycle
16

Oven Light

TROUBLESHOOTING

to possibly avoid the cost of a service call.
www.maytag.com
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Range is in Sabbath Mode.
The control knob is set
incorrectly.
The range is in Demo Mode.
Cookware that is not the proper
size
Control knob set to incorrect heat
level
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
The range is in Demo Mode.
Oven door is open.
Oven temperature calibration
needs adjustment
Temperature has been changed
to Fahrenheit or Celsius.
Needs service (oven indicator
lights are flashing)
Power failure (display shows
flashing time)
Error code (display shows letter
followed by number)
Tap water was used in the Clean
cycle.
Range is not level.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See "Sabbath Mode" section.
Push in knob before turning to a setting.
Demo Mode will deactivate the Warming Center element. See
"Demo Mode" in the "Electronic Oven Controls" section.
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
Close oven door. See "Convection Cooking" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Fahrenheit and Celsius" in the Electronic Oven Controls"
section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Press the CANCEL keypad to clear the display. See "Control
Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See cover for contact information.
Use distilled or filtered water in the Clean cycle.
To remove deposits, use a cloth soaked with vinegar. Then use
a cloth dampened with water to thoroughly remove any vinegar
residue.
Mineral deposits will collect on dry areas of the oven bottom
during the Clean cycle. Level the range. See the Installation
Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use
a cloth dampened with water to thoroughly remove any vinegar
residue.