HP ProCurve 2824 Install Manual: Mbps Or 100 Mbps Network Connections; Cable Diagram; Pin Assignments

Hp procurve 2824: install guide.
Hide thumbs
Switch Ports and Network Cables
Twisted-Pair Cable/Connector Pin-Outs
Straight-Through Twisted-Pair Cable for

10 Mbps or 100 Mbps Network Connections

Because of the MDI/MDI-X operation of the 10/100 ports on the switch, for all
network connections, to PCs, servers or other end nodes, or to hubs or other
switches, you can use "straight-through" cables.
If any of these ports are given a fixed configuration, for example 100 Mbps/
Full Duplex, the ports operate as MDI-X ports, and straight-through cables
must be then used for connections to PC NICs and other MDI ports.
Cable Diagram
N o t e
Pins 1 and 2 on connector "A" must be wired as a twisted pair to pins 1 and 2
on connector "B".
Pins 3 and 6 on connector "A" must be wired as a twisted pair to pins 3 and 6
on connector "B".
Pins 4, 5, 7, and 8 are not used in this application, although they may be wired
in the cable.
.
Pin Assignments
B-6
Switch End (MDI-X)
Signal
Pins
receive +
1
receive -
2
transmit +
3
transmit -
6
Computer, Transceiver, or
Other End
Pins
Signal
1
transmit +
2
transmit -
3
receive +
6
receive -

Advertising

   Also See for HP ProCurve 2824

   Related Manuals for HP ProCurve 2824

   Related Content for HP ProCurve 2824

This manual also for:

Procurve 2848, J4904a, J4903a

Comments to this Manuals

Symbols: 0
Latest comments: