HP J4111A Installation Manual page 8

Procurve switch module
Hide thumbs Also See for J4111A:
Table of Contents

Advertisement

Descriptions
2
Contact your HP-authorized networking products reseller or your HP repre-
sentative for information on availability of other modules. You can also visit
the HP networking products Web site at http://www.hp.com/go/procurve to
get more information.
Link and Mode LEDs
Example: The HP ProCurve 4-Port 100Base-FX Module
Features: The HP ProCurve Switch Modules have the following features:
auto-enabled ports—the ports are all configured to be ready for network
I
operation as soon as a viable network cable is connected
I
auto-configuration—a default configuration is applied to the module
when the switch is powered on and the module passes self test; this default
configuration works well for most network installations
LEDs that provide information on the link status, network activity,
I
connection bandwidth, and communication mode (half or full duplex)
I
"hot swap" operation—you can add a module or replace a module without
having to shut down the switch (changing the module type in a given slot
does require a switch reset)
standards adherence:
I
the 10/100Base-T Module (HP J4111A) is compatible with the
IEEE 802.3 10Base-T and IEEE 802.3u 100Base-TX standards
the 100Base-FX Module (HP J4112A) is compatible with the
IEEE 802.3u 100Base-FX standard
the Gigabit-SX Module (HP J4113A) and Gigabit-LX Module
(HP J4114A) are compatible with the IEEE 802.3z Gigabit-SX and
Gigabit-LX standards
the 100/1000Base-T Module (HP J4115B) is compatible with the
IEEE 802.3u 100Base-TX and IEEE 802.3ab 1000Base-T standards
the 10Base-FL Module (HP J4118A) is compatible with the
IEEE 802.3j 10Base-FL standard
network ports
retaining screw

Advertisement

Table of Contents
loading

Table of Contents