Page of 2

HP Photosmart 140 Setup Manual

Hp photosmart 140: setup guide.
Hide thumbs
   
setup
guide
1
Q3025-90153
*Q3025-90153*
hp photosmart
140 series
HP #57
2
plug in the power cord
Place the printer at least 10 inches (250 mm)
away from any obstruction to allow space for the
paper to move through the printer during printing.
1. Connect the power cord to the back of your
printer.
2. Plug the power cord into a working electrical
outlet.
Important: Make sure the power cord does not
block the rear paper path.
3
load an index card
Note: The index card will be used to print a
calibration page in step 6.
1. Open the paper tray door.
2. Place an index card from the sample pack on
the paper tray and slide the card underneath
the output guide.
3. Move the paper width guide to fit close to the
left edge of the index card without bending
the card.
Rear paper path
Paper width guide
Paper tray
Output guide

Advertising

   Also See for HP Photosmart 140

   Related Manuals for HP Photosmart 140

   Summary of Contents for HP Photosmart 140

  • Page 1: Unpack Your Printer

    140 series HP #57 plug in the power cord Place the printer at least 10 inches (250 mm) away from any obstruction to allow space for the paper to move through the printer during printing. 1. Connect the power cord to the back of your printer.

  • Page 2: Remove The Tape, Install The Print Cartridge

    3. Insert a memory card that contains digital photos into the correct memory card slot. Note: Push the memory card into the printer until it stops—it does not insert all the way into the printer. The memory card light flashes while the printer reads the memory card.

Comments to this Manuals

Symbols: 0
Latest comments: