Consult your dealer or an experienced radio/TV technician. Any changes or modifications to the printer that are not expressly approved by HP could void the user’s authority to operate this equipment. Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules.
Preparation/ Review package contents. Make sure all parts are included. 1) HP LaserJet 1200 series printer. 2) Toner cartridge (in protective bag). 3) Getting Started Guide. 4) Software and electronic user guide (on CD-ROM). 5) Power cord. 6) Printer media input tray. 7) Printer priority media input tray.
Open the toner door. Pull the sides of the door forward until the door locks in its open position. Leave the door open until step 7. Connect USB or parallel cable to printer. The HP LaserJet 1200 printer includes USB and parallel ports. Connect one cable to the proper port and run the cable through the cable slot.
2) Slide the complete assembly in at an angle and then down until it fits securely in the printer. 3) Remove the tape and lift off the printer priority media input tray (top tray). 4) Slide the media guides out and back...
Install the printer software. Insert the CD for your software installation or go to the Plug and Play section. Test the printer. Wait until the ready light is illuminated and press the Go button. A configuration page, showing the printer’s current configuration, should print in 10 seconds.
HP LaserJet 1200 Installing on Macintosh (USB). 1) Run the installer, then restart. 2) Run the Apple Desktop Printer utility. 3) Select HP Printer (USB). 4) Click Change. 5) Select HP LaserJet. 6) Click Auto Setup, then Create. Macintosh (USB)
3) If all lights are blinking, remove the DIMM and replace it with a new DIMM, if necessary. 4) If all lights are on, unplug the printer, wait 5 minutes, plug it back in, and retry. If errors still exist, call HP Customer Support.
Installing on Windows 2000 (USB). 1) Connect the I/O cable to the computer. 2) Reboot the computer. 3) In the Found New Hardware wizard, click Next. 4) Select Search for a suitable driver for my device (recommended), and click Next. Windows 2000 (USB) Installing on Windows 9X and Millennium (Parallel).
Installing on Windows NT (Parallel). (Note: You must have administrator privileges.) 1) When the Installation wizard appears, click Software Installation. 2) Follow the instructions on your screen. Windows NT 5) Select Specify a location. 6) Under Copy manufacturer’s files from, type x:\2000\ (where x is the letter of your CD-ROM drive), and click OK.
2002 Hewlett-Packard Co. www.hp.com/support/lj1200 *C7044-90939* *C7044-90939* C7044-90939...