Operating The Dishwasher; Start/Delay/Cancel/Interrupt; Extra Dry Heat; Cycle Completion Signal - Bosch SHE68R55UC Use And Care Manual

Operating the Dishwasher

Start the dishwasher:
1
Open the door and press the On/Off button.
2
Select a cycle and desired options.
3
Close the door to begin the cycle.
Delay start:
1
Open the door and press the On/Off button.
2
Select a cycle.
3
Press and hold the Delay Start button. Release when the desired delay time is shown in the display window.
4
Close the door to begin the cycle.
Cancel a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press and hold the two buttons labeled Cancel/Reset for 3 seconds.
3
Close the door and wait about 1 minute while the dishwasher drains.
4
Open the door and press the On/Off button. You may now start a new cycle
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CARE-
FULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the On/Off button to turn the unit off.
3
Wait at least 10 seconds before fully opening the dishwasher door.
4
To resume the cycle, press the On/Off button and close the dishwasher door.

Extra Dry Heat:

1
Press and hold the Auto button, then press and hold the On/Off button.
2
When the LED display window indicates a "0" or "1" release both buttons.
3
To activate Extra Dry Heat, press the Auto button until the display indicates "1".
4
To disable Extra Dry Heat, press the Auto button until the display indicates "0".
5
Press the On/Off button to save the setting.

Cycle completion signal:

The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the
dishes. You can choose to disable the tone or adjust the volume.
To activate:
1
With the unit OFF, press and hold the right of the two Cancel/Reset buttons and then press and hold the On/
Off button.
2
When the light on the Cancel/Reset button you are pressing illuminates and the tone goes off, release both buttons.
3
Press the right of the two Cancel/Reset buttons again until you achieve the desired volume or until there is
no tone (to turn cycle completion signal OFF).
4
Press the On/Off button to save the setting.
SHE55RF5UC, SHE68R5xUC and SHX68R5xUC front display key:
Check water inlet
12
WARNING
Sensors OK Spray pressure Do not open door
Rinsing
Washing
Program progress
.
Sanitation rinse
Drying