Using the Auto-Adjustment Function
You can optimize the screen performance for the VGA (analog) input by using the
monitor and the auto-adjustment pattern software utility on the CD provided.
Do not use this procedure if the monitor is using a DVI input. If the monitor is using a VGA (analog)
input, this procedure can correct the following image quality conditions:
●
Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
To use the auto-adjustment feature:
1.
Allow the monitor to warm up for 20 minutes before adjusting.
2.
Press the
●
You can also press the
Refer to
●
If the result is not satisfactory, continue with the procedure.
3.
Insert the CD in the disc drive. The CD menu is displayed.
4.
Select Open Auto-Adjustment Software. The setup test pattern is displayed.
5.
Press the
6.
Press the
-/Auto
button on the monitor front panel.
Menu
Adjusting the Monitor Settings on page 25
-/Auto
button on the monitor front panel to produce a stable, centered image.
ESC
key or any other key on the keyboard to exit the test pattern.
button, then select Image Control from the OSD Main Menu.
in this chapter.
Using the Auto-Adjustment Function
-/Auto
button on the
23