HP L1750 User Manual page 26

3. Place the optional HP Quick Release onto the back of the monitor. Line up the holes on the HP
Quick Release with the mounting holes on the back of the monitor.
Figure 3-19
4. Insert four 10mm screws into the mounting holes and tighten.
NOTE:
that connected the monitor panel with the pedestal base, or use the four M4 x 10 mm screws that
are provided in the VESA mounting holes on the back of the monitor panel.
18 Chapter 3 Setting Up the Monitor
Mounting the HP Quick Release
Depending on your model, use the screws that were removed from the back of the monitor