Computer Tilt Feet - HP ProSignia 120 Maintenance And Service Manual

Hp prosignia 120: user guide
Table of Contents

Advertisement

5.4 Computer Tilt Feet

There are two tilt feet on the bottom of the computer. To remove a foot, follow the
steps listed.
1. Turn the computer bottom side up and position it so that the front of the unit is
toward you.
2. Open the foot to the fully extended position.
3. Place a flat-blade screwdriver between the right hinge point of the foot and the unit.
The tip of the blade must be under one end of the foot, immediately below the hinge
point. Be careful not to mar or scratch the plastic base enclosure.
4. Press the foot toward the closed position, and simultaneously press down the handle
of the screwdriver toward the table. The foot will snap out of the hinges.
Figure 5-5. Removing the Computer Tilt Feet
To replace the foot, place the left end of the hinge on the hinge point. Rotate the right
end of the hinge into position over the right hinge point and press firmly. The hinge
will snap into place with moderate pressure.
Removal and Replacement Procedures 5-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents