Audio Technica Uno-Pak ATW-T1001 Additional Instructions For Installation And Operation

Microphone / Instrument Level Control
Pairing Switch
Screwdriver
System ID Display
Figure G — ATW-T1001 UniPak
UniPak ® Transmitter Battery Installation
1. Slide off the battery cover.
2. Carefully insert two fresh AA alkaline batteries, observing polarity
markings.
3. Replace the battery cover (Fig. G).
UniPak ® Transmitter Power/Mute/Battery Indicator
After the battery is installed, press and hold the Power/Mute button
until the indicator LED turns green (Fig. H). If the indicator LED does not
light up when the power button is pressed, the batteries are installed
incorrectly or they are dead. The indicator LED will flash to show low-
battery condition.
UniPak ® Transmitter Mute Function
With the transmitter on, a slight touch of the Power/Mute button will
toggle between muted and unmuted operation. Red indicator LED shows
muted operation. Green indicator LED shows unmuted operation.
UniPak Transmitter Mute Lock Function
®
Transmitter must be off to activate mute lock. Press and hold the Pairing
Switch and then press and hold the Power/Mute button until transmitter
powers on. There is no dot next to the System ID when mute
Note:
lock is activated.
Transmitter must be off to deactivate mute lock. Press and hold the
Pairing Switch and then press and hold the Power/Mute button until
transmitter powers on. When deactivated, a dot will display next to the
System ID.
UniPak ® Transmitter Input Connection
Connect an audio input device (microphone or guitar cable) to the
audio input connector on the top of the transmitter. A number of
Audio-Technica professional microphones and cables are available
separately, pre-terminated with a UniPak
www.audio-technica.com).
UniPak Transmitter Antenna
®
The UniPak transmitter includes a permanently-attached antenna. If
®
the received signal is marginal, experiment with different transmitter
positions on your body or instrument; or try repositioning the receiver.
Do not attempt to remove, replace or change the length of the
transmitting antenna.
UniPak Transmitter Pairing Switch
®
Used to complete pairing sequence. See page 6.
UniPak ® Transmitter Microphone/Instrument Level Control
Used to set microphone/instrument level. See page 6.
System 10 Portable Camera-Mount Wireless Installation and Operation
Transmitter
®
input connector (see
®
Battery Compartment
Figure H — UniPak
Antenna
UniPak Transmitter Screwdriver
®
Used to adjust Level Control. See page 6.
UniPak Transmitter System ID Display
®
Shows System ID. See page 6.
assigned to a paired receiver and transmitter for identification purposes.
When power is applied, the System ID Display on the transmitter glows
bright and then turns off to conserve battery life. To turn the System ID
Display back on, mute and unmute the transmitter.
Transmitter
®
Power/Mute
Button
Input
Connector
Indicator LED
(Power/Mute/Battery)
Note: System ID is an identical number
5