Unfolding The Stroller; Installing The Front Wheels - Joovy 430 Instruction Manual

Unfolding the stroller

• Keep children away from stroller while unfolding.
• Position the stroller with the handle bar closest to you.
• Release the locking latch located on the right side by lifting the lever off of the
extended rivet. See Figure 2.
• Lift up slightly on the handle of the stroller. Then place one foot onto the rear
platform and pull up and back on the handle until both side frame bars snap into
their locking positions in the frame.
CAUTION: While unfolding the stroller, be careful to keep your fingers from
being pinched by moving parts.
• Lock the safety latches on the lower portion of each side of the stroller by
pushing the lever down over the extended rivet. See Figure 3.
• Ensure that the stroller is completely opened and the safety latches are secured
before ANY use of the stroller.
Figure 
ALWAYS secure the safety latches on the sides of the stroller
when it is in the unfolded use position. This will prevent
collapse of the stroller should the handle trigger locks be

Installing the Front Wheels

• Take one of the double wheel sets and locate the small hole in the rotating
bracket that is inside the red lever.
• Push the front axle into this hole and keep pushing the wheel set onto this axle
until you hear an audible click. See Figure 4.
• Pull downward on the wheel set to be sure that it has locked into position on the
axle.
• Repeat this same procedure for the other wheel set.
• When assembled properly, both wheel sets should rotate and roll smoothly
when the stroller is pushed.
Page 
Figure 
WARNING
accidentally opened.
The Big Caboose Stand-On Triple Instruction Manual