Table of Contents
Advertisement
Installing a hard drive
1.
Grasp the tab on the hard drive, and lower the hard drive into the hard drive bay (1).
2.
Replace the 3 hard drive screws (2).
3.
Insert the hard drive cable into the cable routing channel.
4.
Grasp the tab on the hard drive cable connector (3), and then carefully press the hard drive
cable connector onto the system board until it snaps into place.
5.
Replace the vanity cover:
a.
Insert the 4 tabs on the front edge of the vanity cover into the 4 slots in the base (1).
b.
Rotate the back edge (2) of the vanity cover toward you, and then firmly press it down until
it snaps into place.
6.
Insert the battery (3) (see
32
Chapter 7 Drives
Inserting the battery on page
24).
Advertisement
Table of Contents
