●
WLAN module (see
●
Memory module (see
●
RTC battery (see
RTC battery on page
●
Fan/heat sink assembly (see
Remove the system board:
1.
Disconnect the display panel cable from the system board.
2.
Disconnect the power connector cable from the system board.
3.
Remove the Phillips PM2.0×4.0 screw (1) that secures the system board to the base enclosure.
4.
Lift the right side of the system board (2) until it rests at an angle.
WLAN module on page
Memory module on page
47)
Fan/heat sink assembly on page
42)
45)
65)
Component replacement procedures
63