Display Assembly - HP ENVY 17-2090 Maintenance And Service Manual

3. Remove the subwoofer (4).
NOTE:
installed in screw holes.
Reverse this procedure to install the subwoofer.

Display assembly

NOTE: The display assembly spare part kit includes a display panel cable, webcam/microphone
module and cable, and 2 wireless antenna cables and transceivers.
Description
17.3-in, AG, FG, 3D
17.3-in AG, FG, FHD
17.3-in AG, FG, HD
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hard drive cover (see
b. memory module compartment cover (see
70 Chapter 4 Removal and replacement procedures
When removing the subwoofer, make note of the location of the isolators (5) that are
Battery on page
Primary hard drive on page
37), and then remove the following components:
38)
Memory module on page
Spare part number
620775-001
603774-001
603773-001
42).