Audio/Expresscard Assembly - HP EliteBook 6930p Maintenance And Service Manual

Reverse this procedure to install the speaker.

Audio/ExpressCard assembly

Description
Audio/ExpressCard assembly (includes ExpressCard slot, cable, headphone and microphone
connectors, and SD card reader slot)
Before removing the audio/ExpressCard assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Keyboard (see
c. Switch cover (see
d. Display assembly (see
e. Top cover (see
f. Bluetooth module cable (see
g. Speaker (see
Remove the audio/ExpressCard assembly:
1. Release the ZIF connector (1) to which the audio/ExpressCard assembly cable is attached, and
disconnect the audio/ExpressCard assembly cable from the system board.
2. Lift the right side of the audio/ExpressCard assembly (2) to disconnect it from the system board.
Battery on page
Hard drive on page 49)
Keyboard on page 57)
Switch cover on page
Display assembly on page
Top cover on page 82)
Bluetooth module cable on page
Speaker on page 88)
43).
66)
77)
Component replacement procedures
Spare part number
482959-001
87)
89