Setting Power Preferences; Changing The Power Switch Function; Setting A Standby Password - HP Compaq tc1100 Software Manual

Power

Setting Power Preferences

Changing the Power Switch Function

By default, sliding and releasing the power switch while the
tablet PC is on initiates Standby.
To change the function of the power switch:
1. Select Start > Control Panel > Performance and
2. From the list for When I Press The Power Button On
3. Select the OK button.
✎
The Hibernate function is available only if Hibernation is
enabled. To verify that Hibernation is enabled, refer to the
instructions in the

Setting a Standby Password

To set the tablet PC to prompt for a password when exiting
Standby:
1. Select Start > Control Panel > Performance and
Maintenance icon > Power Options icon > Advanced tab.
2. Select the check box for Prompt for Password When
Computer Resumes From Standby.
3. Select the OK button.
At the password prompt that is displayed when resuming from
Standby, enter a password that was set in the operating system,
not a password that was set in the Setup utility. Passwords set in
the operating system and passwords set in the Setup utility can be
the same. For more information about using passwords, see
Chapter 4,
1–10
Maintenance icon > Power Options icon > Advanced tab.
My Computer, select a power switch function.
"Hibernation"
"Passwords."
section earlier in this chapter.
Software Guide