Power Management; Setting Power Options; Using Power-Saving States; Initiating And Exiting Sleep - HP Compaq Presario,Presario C500 User Manual

3

Power management

Setting power options

Using power-saving states

Windows has two power-saving states enabled at the factory: Sleep and Hibernation.
When you initiate Sleep, the power lights blink and the screen clears. Your work is saved to memory,
letting you exit Sleep faster than exiting Hibernation. If the computer is in the Sleep state for an extended
period or if the battery reaches a critical battery level while in the Sleep state, the computer initiates
Hibernation.
When you initiate Hibernation, your work is saved to a hibernation file on the hard drive and the computer
turns off.
CAUTION
functionality, or loss of information, do not initiate Sleep or Hibernation while reading from or
writing to a disc or an external media card.
NOTE
functions while the computer is in the Sleep state or in Hibernation.

Initiating and exiting Sleep

The system is set at the factory to initiate Sleep after 10 minutes of inactivity when running on battery
power and 25 minutes of inactivity when running on external power.
Power settings and timeouts can be changed using Power Options in Windows Control Panel.
With the computer on, you can initiate Sleep in any of the following ways:
●
Press the power button.
●
Close the display.
●
Click Start, and then click the Power button.
●
Click Start, click the arrow next to the Lock button, and then click Sleep.
You can exit Sleep in any of the following ways:
●
Press the power button.
● If the display is closed, open the display.
24 Chapter 3 Power management
To prevent possible audio and video degradation, or loss of audio or video playback
You cannot initiate any type of networking communications or perform any computer
ENWW