Start Procedure - Chicago Electric 66619 Operation And Service Instructions Manual

FIGURE c
STRAINER
(74)
3. Remove the Fuel Tank Cap (76) and
check the fuel level.
(See Figure c.)
WARNING! To PREvENT
SERIoUS INjURY FRoM FIRE:
Fill the Fuel Tank (73) in a well-
ventilated area away from ignition
sources. Do not smoke.
4. To fill the Fuel Tank (73), first wipe off the
Fuel Tank Cap (76) and the surrounding
area.
(See Figure c.)
5. Unscrew, and remove the Fuel Tank Cap
(76). (See Figure c.)
6. Remove the Strainer (74) and remove
any dirt and debris. Then replace the
Strainer. (See Figure c.)
7. Fill the Fuel Tank (73) to about 1 inch
under the fill neck of the Tank with the
pre-mixed unleaded gasoline/2-cycle oil
mixture.
8. Then replace the Fuel Tank Cap (76).
(See Figure c.)
SKU 66619
FUEl
TANK
cAP
For technical questions, please call 1-800-444-3353.

Start Procedure:

before starting the Engine:
a.
b.
(76)
c.
FUEl
SWITch
1. Turn the Engine Fuel Switch (80) to its
"oPEN" position. (See Figure D.)
choKE
lEvER
(82)
2. Turn the Engine Choke Lever (82) to its
"choKE" position. Set the Choke Lever
Inspect the Generator and Engine.
Fill the Fuel Tank (73) with the
proper amount and type of
unleaded gasoline and 2-cycle oil.
(See Figures b and c.)
NOTE: Only after the Generator
has stabilized and is running
smoothly should an appliance or
tool be plugged into the AC Outlet
of the Generator.
FIGURE D
(80)
"oPEN"
FIGURE E
"choKE"
"RUN"
Page 10