Diagnostics Menu; System Configuration Menu - HP Compaq NX6315 Setup Manual

Computer setup
Hide thumbs Also See for Compaq NX6315:
Table of Contents

Advertisement

Diagnostics menu

Select
Hard Drive Self-Test options
Memory Check
Startup Check (select models only)

System Configuration menu

NOTE:
computer.
Select
Language (or press f2)
Boot options
Device configurations
6
Chapter 3 Computer Setup menus
Some of the listed System Configuration options may not be supported by your
To do this
Run a comprehensive self-test on any hard drive in the system
or on any optional MultiBay hard drive.
Run a comprehensive check on system memory.
Verify the system components needed for starting the
computer.
To do this
Change the Computer Setup language.
Set f9, f10, and
f12
delay when starting up.
Enable/disable CD-ROM boot.
Enable/disable floppy boot.
Enable/disable internal network adapter boot and set the
boot mode (PXE or RPL).
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
Set the Express Boot Popup delay in seconds.
Set the boot order.
Swap the functions of the
Enable/disable multiple standard pointing devices at
startup. (To set the computer to support only a single,
usually nonstandard, pointing device at startup, select
Disable.)
Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
Use of a USB keyboard, mouse, and hub in
Computer Setup even when a Windows operating
system is not running.
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer or to an optional docking
device (select models only).
Select a parallel port mode: EPP (Enhanced Parallel
Port), standard, bidirectional, or ECP (Enhanced
Capabilities Port).
Enable/disable BIOS DMA data transfers.
fn
key and left
ctrl
key.
ENWW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents