Table of Contents
Advertisement
A4.
MOUNT THE MICROWAVE
OVEN (cont.)
5
Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
7 Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
8
Install grease filters. See the Use & & & & a nd Care
packed with the microwave.
A5.
INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
NOTE: The charcoal filter is factory installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
For models without the recirculation filter access
door,follow these steps to replace or install a charcoal
filter.
A 5.1
Unplug microwave oven or disconnect power.
Installation Instructions
EN-12
A 5.2
Open the microwave door and remove the two
vent mounting screws ; l ocated on top of the
microwave using a #1 Phillips screwdriver.
A 5.3
Remove the charcoal filter by pushing the
top of the filter inwards,then pull it forward
out from the unit.
A 5.4
Slide the top of the new charcoal filter into the
top of the filter cavity.
Charcoal
Filter
Advertisement
Table of Contents
