Frigidaire FPID2498SF5A Use & Care Manual page 19

Table of Contents

Advertisement

Etching
Using too much detergent especially in soft
or softened water causes damage that looks
like a fi lm but cannot be removed.
Adjust the amount of detergent based
on the water hardness. (Check Detergent
Chart).
Lower the water temperature.
Dishwasher has an Odor
Soiled dishes left in dishwasher too long can
create an odor. Use Rinse Only cycle.
There will be a "new" smell when fi rst
installed. This is normal.
Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly).
Vapor at Vent
Spilled rinse aid can cause foam and lead
to overfl owing. Wipe up any spills with a
damp cloth.
Check to see that dishwasher is level. (See
Installation Instructions).
Dishwasher Won't Run
Check to see if circuit breaker is tripped or if
a fuse is blown.
Make sure water supply is turned on.
Check to see if cycle is set correctly. (See
Operating Instructions).
Is dishwasher set for Delay Start Option?
Make sure door is closed and latched.
Glassware/Flatware Spotted or Cloudy
Check water hardness. For extremely hard
water, it may be necessary to install a water
softener. (See Detergent Chart).
Water temperature may be low. Avoid
extremely low or high temperatures. (See
Factors Affecting Performance.
Avoid overloading and improper loading. (See
Preparing and Loading Dishes).
Use fresh detergent. Old detergent is
ineffective.
Make sure rinse aid dispenser is fi lled.
Check to see that proper amount of
detergent is being used for cycle selected.
Also, check phosphate level. (See Detergent
Dispenser.)
Home water pressure may be too low - it
should be 20 to 120 pounds per square inch
(psi).
Dishwasher Won't Fill
Is water supply turned on?
BEFORE YOU CALL
Stains on Tub Interior
Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-rinsing
or using the Rinse Only cycle will reduce the
chance of staining. Using air dry option will
lessen staining.
Dishwasher Does Not Drain Properly
If unit is hooked up to a food waste disposer,
make sure the disposer is empty.
Check to see if the knockout plug has been
removed from inside the food waste disposer
inlet.
Check to see if drain hose is kinked.
Make sure cycle is complete, not in a pause.
Opening the door during cycle
If the dishwasher door is opened while the
unit is running, the START/CANCEL pad must
be pressed and the door shut immediately
to return the unit to the selected cycle and
option.
Removing Spots and Film
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses
may also get spots and fi lm for a number of
reasons. (See Glassware/Flatware Spotted or
Cloudy section). To remove buildup, and fi lm,
clean using the following instructions:
1.
Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2.
Do not add detergent.
3.
Select the NORMAL cycle. Press START/
CANCEL pad. Close and latch the door.
4.
Allow dishwasher to run until it starts the
second water fi ll (approximately 10 minutes).
5.
Unlatch an and open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
6.
Close and latch door and allow cycle to fi nish.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fpid2498sf2a

Table of Contents