Parts Description; Installation; Bench Mounting - Makita DLS111ZU Instruction Manual

PARTS DESCRIPTION

► Fig.2
1 Slide pole
5 Holder
9 Kerf board
13 Blade guard
17 Adjusting bolt (for maxi-
mum cutting capacity)
21 Releasing lever (for turn
base)
► Fig.3
1 Switch trigger
5 Switch (for laser line)
(For DLS111, DLS112
only)
9 Wireless activation
button
13 Guide fence (lower
fence)
17 Bevel angle scale
21 45° adjusting bolt (for
bevel angle)

INSTALLATION

Installing the grip
Screw the threaded shaft of the grip into the turn base.
► Fig.4: 1. Grip 2. Turn base
Installing the dust extraction hose
Connect the dust extraction hose to the tool as
illustrated.
Make sure that the elbow and the sleeve fit properly to
the ports of the tool.
► Fig.5: 1. Dust extraction hose 2. Elbow 3. Sleeve
4. Port
To remove the elbow from the port, pull the elbow while
pressing down the lock button.
► Fig.6: 1. Lock button 2. Elbow
2 Stopper pin (for carriage
sliding)
6 Turn base
10 Blade case
14 Knob (for bevel angle)
18 Stopper arm
22 Grip (for turn base)
2 Lock-off button
6 Battery indicator
10 Wireless activation lamp
14 Guide fence (upper
fence)
18 Releasing lever (for 48°
bevel angle)
- -
3 Vertical vise
7 Pointer (for miter angle)
11 Adjusting screw (for
laser line)
15 Hex wrench
19 Battery cartridge
- -
3 Hole for padlock
7 Mode indicator
11 Hose (for dust
extraction)
15 Dust bag
19 Latch lever (for bevel
angle)
- -

Bench mounting

When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. While lowering the
handle slightly, pull the stopper pin and rotate it 90°.
► Fig.7: 1. Locked position 2. Unlocked position
3. Stopper pin
This tool should be bolted with four bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
► Fig.8: 1. Bolt
WARNING:
on the supporting surface. Movement of the miter
saw on the supporting surface while cutting may
result in loss of control and serious personal injury.
22 ENGLISH
4 Releasing button (for
right side bevel angle)
8 Miter angle scale
12 Range adjustment screw
(for laser line)
16 Adjusting screw (for
lower limit position)
20 Lock lever (for turn base)
-
4 Lid (for wireless unit)
(For DLS111 only)
8 Check button
12 Stopper pin (for carriage
elevation)
16 0° adjusting bolt (for
bevel angle)
20 Pointer (for bevel angle)
-
Ensure that the tool will not move
-
-