Advanced Bios Features - Gigabyte GA-946GM-DS2 User Manual

2-2

Advanced BIOS Features

CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
Hard Disk Boot Priority
First Boot Device
Second Boot Device
Third Boot Device
Password Check
HDD S.M.A.R.T. Capability
CPU Hyper-Threading
Limit CPUID Max. to 3
No-Execute Memory Protect
CPU Enhanced Halt (C1E)
CPU Thermal Monitor 2(TM2)
CPU EIST Function (Note)
Virtualization Technology
Init Display First
Onboard VGA
On-Chip Frame Buffer Size
: Move Enter: Select
F5: Previous Values
Hard Disk Boot Priority
Select boot sequence for onboard(or add-on cards) SCSI, RAID, etc.
Use < > or < > to select a device, then press<+> to move it up, or <-> to move it down the list.
Press <ESC> to exit this menu.
First / Second / Third Boot Device
Floppy
LS120
Hard Disk
CDROM
ZIP
USB-FDD
USB-ZIP
USB-CDROM
USB-HDD
LAN
Disabled
Password Check
Setup
System
If you want to cancel the setting of password, please just press ENTER to make [SETUP] empty.
HDD S.M.A.R.T. Capability
This feature allows your hard disk to report read/write errors and to issue warnings when third-
party hardware monitor utility is installed.
Enabled
Disabled
(Note) This item will show up when you install a processor that supports this function.
GA-946GM-DS2/S2 (rev. 2.0) Motherboard
Advanced BIOS Features
[Press Enter]
[Floppy]
[Hard Disk]
[CDROM]
[Setup]
[Disabled]
[Enabled]
(Note)
[Disabled]
(Note)
[Enabled]
(Note)
[Enabled]
(Note)
(Note) [Enabled]
[Enabled]
[Enabled]
(Note)
[PCI]
[Enable If No Ext PEG]
[8MB]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Select your boot device priority by Floppy.
Select your boot device priority by LS120.
Select your boot device priority by Hard Disk.
Select your boot device priority by CDROM.
Select your boot device priority by ZIP.
Select your boot device priority by USB-FDD.
Select your boot device priority by USB-ZIP.
Select your boot device priority by USB-CDROM.
Select your boot device priority by USB-HDD.
Select your boot device priority by LAN.
Disable this function.
The system will boot but will not access to Setup page if the correct
password is not entered at the prompt. (Default value)
The system will not boot and will not access to Setup page if the correct
password is not entered at the prompt.
Enable HDD S.M.A.R.T. capability.
Disable HDD S.M.A.R.T. capability. (Default value)
- 34 -
Item Help
Menu Level
Select Hard Disk Boot
Device Priority
F10: Save ESC: Exit
F7: Optimized Defaults
F1: General Help