2-4
Power Management Setup
ACPI Suspend Type
Power LED in S1 state
Off by Power button
AC BACK Function
PME Event Wake Up
ModemRingOn
Resume by Alarm
x Date (of Month) Alarm
x Time (hh:mm:ss) Alarm
POWER ON Function
: Move
Enter: Select
F5: Previous Values
ACPI Suspend Type
S1(POS)
Set ACPI suspend type to S1/POS(Power On Suspend). (Default value)
S3(STR)
Set ACPI suspend type to S3/STR(Suspend To RAM).
Power LED in S1 state
Blinking
In standby mode(S1), power LED will blink. (Default value)
Dual/Off
In standby mode(S1):
a. If use single color LED, power LED will turn off.
b. If use dual color LED, power LED will turn to another color.
Off by Power button
Instant-off
Press power button then Power off instantly. (Default value)
Delay 4 Sec.
Press power button 4 seconds to Power off. Enter suspend if button is pressed less
than 4 seconds.
AC BACK Function
Soft-Off
When AC-power back to the system, the system will be in "Off" state. (Default value)
Full-On
When AC-power back to the system, the system always in "On" state.
Memory
When AC-power back to the system, the system will return to the Last state before
AC-power off.
PME Event Wake Up
This feature requires an ATX power supply that provides at least 1A on the 5VSB lead.
Disabled
Disable this function.
Enabled
Enable PME as wake up event. (Default value)
ModemRingOn
An incoming call via modem can awake the system from any suspend state.
Disabled
Disable Modem Ring On function.
Enabled
Enable Modem Ring On function. (Default value)
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Power Management Setup
[S1(POS)]
[Blinking]
[Instant-Off]
[Soft-Off]
[Enabled]
[Enabled]
[Disabled]
Everday
0 : 0 : 0
[Disabled]
+/-/PU/PD: Value
F6: Fail-Save Defaults
- 39 -
Item Help
Menu Level
F10: Save
ESC: Exit
F7: Optimized Defaults
F1: General Help
BIOS Setup