Attaching And Aligning The Custom Door Front - Miele F 1801 Vi Operating And Installation Instructions

Installing the appliance
Attaching and aligning the
custom door front
^ Fit the door handle to the custom
door.
Note that the screws are applied from
the reverse side.
^ Open the door and hang the custom
door with the adjusting rail over the
double-threaded bolts p.
^ Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^ Close the door.
^ Adjust the custom door to adjacent
furniture/fixtures.
^ Align the custom door with the
double-threaded bolts.
64
^ Tighten the nuts on the adjusting rail.
This will correct the side alignment of
the door.
^ Put the side strips (15) back into place
and screw them completely down on
both sides of the appliance door.
^ Align the custom door again as needed
and tighten all screws on the sides.
Attaching the lower bracket
(Only for appliances using the "Front
panel gap kit".)
^ Open the appliance door.
^ Screw on the lower brackets. Pre-drill
holes in the custom door.