Adjusting The Incoming Ring Tone Volume; Turning On The Answer Memo - Hitachi HIY02 User Manual

Adjusting the Incoming Ring
Tone Volume
When the standby screen is displayed, press c.
Use a to select Function and then press
➡
c (Select).
Use j to select Sound/Vib/Lamp and then
➡
press c (Select).
Use j to select Incoming Setup and then press
➡
c (Select).
Use j to select Incoming Call and then press
➡
c (Select).
Use j to select
➡
then press c (Select).
Use j to adjust the volume and then press
➡
c (Set).
Each press of j changes the volume one step.
•
STEP ↑
The ring tone volume gradually increases.
STEP ↓ The ring tone volume gradually decreases.
Level5
The ring tone sounds at the set volume.
Level1
OFF The ring tone does not sound.
Press % (OK).
➡
(Ringtone Volume) and

Turning On the Answer Memo

When the standby screen is displayed, hold down
C for at least one second.
is displayed on the standby screen.
Turning Off the Answer Memo
■
When the standby screen is displayed, hold down C for
at least one second. The answer memo is turned off and
disappears from the standby screen.
• The cell phone can record a maximum of ten
messages, each up to 60 seconds long.
• Answer memo is a function that automatically answers
calls and allows callers to record messages. Use the
Answering Service (Voice Mail) when your phone is
turned off or when you are in a location where a signal
cannot be received.
Playing a Message
■
If a message is recorded, Answer Memo appears
on the standby screen.
Use s to select Answer Memo and then press
➡
c (Select).
Use j to select the message you want to play
➡
and then press c (Play).
To stop playing the message, press c (Stop).
•
17